Miller Electric Manufacturing Co 951291

Description

Miller S-74 MPa Plus CV Wire Feeder For .023″ – 5/64″ Hard Wired And .035″ – 1/16″ Aluminum Wire With Bernard Q400 MIG Gun With 15′ Leads And V-Groove Drive Rolls

Features :

Tool-less rotatable drive assembly allows operator to rotate the drive housing, eliminating severe bends in the wire feed path which reduce gun liner life. Also aids in feeding difficult wires
Automatic run-in control significantly improves arc starts
Trigger hold allows operator to make long welds without having to hold the trigger continuously. Reduces operator fatigue
Posifeed provides positive wire feeding performance through use of the tool less rotatable drive assembly, calibrated drive roll pressure adjustment arm and 24 VDC high-torque, permanent-magnet motor
Alumination technology gives you the ability to use the extended reach of a push-pull system for consistent, versatile and dependable aluminum wire feeding
Alumination gives you the versatility to handle whatever aluminum welding job you want to tackle
Synergic Pulsed MIG operation when optimized with the Invision MPa power supplies. Provides communication between the power source, feeder and gun
As wire speed increases/decreases, the pulse parameters also increase/decrease to match the right amount of power needed
Trigger schedule select allows the operator to select the alternative schedule by quickly tapping the gun trigger when not welding. When optimized with the Invision 352 MPa the operator can also switch from MIG to Pulsed MIG
Profile Pulse gives you the cosmetic bead appearance for the welds you want to show off
Achieve stacked dime weld bead appearance without back-stepping
Profile Pulse frequency can be changed to increase or decrease the spacing between the ripple pattern to achieve the desired weld appearance
Accu-Mate properly seats the power pin for best feeding performance and prevents Accu-Mate grooved MIG guns from sliding in the casting

Product Attributes :

Wire Capacity : 0.078125 in
Machine Model : S-74 MPa Plus
Input Power : 10 AMP, 24 VAC, 50/60 Hz
Power Source Requirement : CV – Constant Voltage
Height : 14 in
Suggested Power Source : DeltaweldSeries, Dimension NT 450, Dimension Series, Invision Mpa, XMTMpa Series, XMTSeries
Wire Type : Aluminum, Hard Wired
Physical Size : 14″ X 12 1/2″ X 28″
Weight : 58 lb
Length : 28 in
MIG Wire Size : .023″ – 5/64″ Hard Wired, .035″ – 1/16″ Aluminum
Width : 12.5 in
Wire Speed IPM : 50 – 780 in/min